DCN: 141-01773-02 1/19/11
20
Main Menu - User Settings - Sensor Calibration
The Sensor Calibration screen allows you to change the temperature calibration of the internal
temperature sensor. You can change the temperature calibration by +/- 7 degrees.
When the Sensor Calibration screen is selected it will show the current temperature calibration (The (75)
in the example screen below) and the current number of degrees of offset being applied (1 deg in the
example). If the sensor’s actual temp is (74) with 0 degrees of offset and you want it to be 75, then press
“+” to add 1 deg and it will show (75).
To change the temperature calibration, use the scroll buttons to select the internal or a remote sensor.
Once selected, use the + and – buttons to change the temperature calibration to the desired setting.
The value shown in the (xx) is the calibrated or offset temperature that you want the sensor to show.
You can refresh the info on this screen by pressing the right hand (blank) button.
When you close this screen, it may take a few seconds for the temperature displayed on the main
thermostat screen to update to the new temperature.
Sensor Calibration Screen
To Next Page
Loading...
Need help?
General
