Installation
Threaded tees
BSP, JIC or Metric sizes are available.
Tapped port
In cases where there is no suitable
coupling, you must drill and tap a 1/8"
BSP port into a convenient pipe block.
If possible remove the component to
be drilled.
Centre punch and drill a 3mm pilot
hole. Open out to 8.8mm dia x 10mm
deep then tap 1/8" BSP.
Ensure all swarf is flushed out of the
pipework, then fit a 1/8" BSPM - 1/4"
BSPM adaptor using a Dowty seal
between the adaptor and block faces.
(fig. 6).
Fig. 5
Fig. 6
To Next Page
Loading...
