Re T-two - Regulator Setup

Re S.p.A. T-two – standard model
Rev. 05/15 5/14
Setting up the regulator
The following is a brief summary of the functions that are available for setting up the tension regulator.
For a complete description, consult Detailed description of the regulator set-up and parameters menu
(P.1) on page 7.
To access the set-up environment press and hold the  for approximately 3 seconds. The letter P.
Appears on the display, followed by the menu identification number. Press the + / – keys to scroll to
the regulator set-up and parameters menu “P.1”. Press and hold the  key again to access the menu.
The display indicates the letter F. followed by the number that identifies the first available function.
Use the + / – keys to scroll through the list of programming functions.
To modify the parameters associated with each individual function, select the desired function, then
press the  key: The display indicates the current parameter value. Use the + / – to set the desired
value, then press the  key to confirm.
To save the new settings, select the first function in the menu and press the – key, or select the last
function and press the + key, after approx. 3 seconds the unit will exit the menu and the data will be
saved.
Regulator set-up and parameters menu (P.1)
Function
ID
Description
Parameter name
Range
Factory
value
F.1
Torque in STOP state (%)
STOP_OUT
0.0÷99.9
10.0
F.3
“Proportional” regulator in AUTO state
AUTO_P
0.0÷99.9
2.0
F.4
“Integral” regulator in AUTO state
AUTO_I
0.00÷9.99
0.80
F.5
“Derivative” regulator in AUTO state
AUTO_D
0.00÷9.99
0.00
F.6
ACC delay state(s)
ACC_TIME
0÷100
0
F.7
“Proportional” regulator in ACC state
ACC_P
0.0÷99.9
2.5
F.8
“Integral” regulator in ACC state
ACC_I
0.00÷9.99
0.40
F.9
“Derivative” regulator in ACC state
ACC_D
0.00÷9.99
0.00
F.11
DEC delay state(s)
DEC_TIME
0÷100
0
F.12
“Proportional” regulator in DEC state
DEC_P
0.0÷99.9
2.5
F.13
“Integral” regulator in DEC state
DEC_I
0.00÷9.99
0.40
F.14
“Derivative” regulator in DEC state
DEC_D
0.00÷9.99
0.00
F.16
“Proportional” regulator in STOP state
STOP_P
0.0÷99.9
0.0
F.17
“Derivative” regulator in STOP state
STOP_D
0.00÷9.99
0.00
F.18
Setpoint (Tension/Position)
SETPOINT
0÷FS
25
F.19
Torque in EMERGENCY state (%)
EMERGENCY_OUT
0.0÷99.9
60.0
F.32
Dancer roll air pressure (%)
DANCER_PRESSURE
0.0÷99.9
0.0
F.33
Tension/position alarm modes
ALARMS_MODE
OFF
A-b
b-A
A-A
b-b
b-A