Recent RS-918SSB - Page 36

LABEL (NR)
DESCRIPTION
when Disp. Pwr
(mW), is
enabled. Needs
SWR meter
hardware
modification to
work. See Wiki
Adjustment and
Calibration.
SWR/PWR Meter FWD/REV
Swap (CONFIG_FWD_REV_SENSE_SWAP)
Exchange the
assignment of
the Power/SWR
FWD and REV
measurement
ADC. Use if your
power meter
does not show
anything during
TX.
I2C1 Bus Speed (CONFIG_I2C1_SPEED)
Sets speed of
the I2C1 bus
(Si570 oscillator
and MCP9801
temperature
sensor). Higher
speeds provide
quicker RX/TX
switching but
may also cause
tuning issues
(red digits). Be
careful with
speeds above
200 kHz.