Record Power DML305 - Troubleshooting; Motor will not start; Motor overheats; Excessive motor noise

22
Problem Possible Cause Solution
Motor will not start Machine not plugged in Plug the machine in
Low voltage Check power supply to machine
Loose connection Check all external connections
Motor overheats Motor overloaded Reduce load on motor
Air flow restricted on motor Clean out motor to obtain normal air flow
Excessive motor noise Faulty motor Have motor checked
Pulley set screw loose Tighten set screw
Motor will not develop Circuit overloaded with lights or Decrease the load on the circuit
full power or stalls other tools
Circuit too long or undersized wires Reduce the length of the wire or use a
suitable diameter cable
Voltage too low Have the voltage checked by an electrician
Circuit breakers do not have sufficient capacity Have a licensed electrician install proper size breaker
Drive belt tension too high Adjust belt tension
Use of extension cord Use heavier gauge extension cord or no extension cord
Machine labours Excessive depth of cut Decrease depth of cut
during cutting Turning tools are dull Sharpen turning tools
14. Troubleshooting
Warning: For your own safety, always turn off and unplug
the machine before carrying out any troubleshooting.
i
Kg
i
Kg
Warning: do not make adjustments while the lathe is
running. Ensure the switch is off, power is disconnected
and all moving parts have stopped before servicing.
Failure to comply may result in serious injury.
i
Kg
i
Kg
i
Kg