Record Power SS16V - 7. Assembly; Location of the Scrollsaw

8
7. Assembly
The SS16V is supplied almost fully assembled, only the dust blower pipe and
blade guard must be fitted before use.
One end of the dust blower pipe is supplied unconnected as shown in Fig
7.1. This loose end must be connected to the bellows cap by pushing it over
the cap as shown in Fig 7.2.
The clear plastic blade guard must be fitted to complete assembly. Take the
nut, bolt and washers supplied and attach the guard to the top of the drop
foot fixing pole as shown in Fig 7.3. Ensure one washer is either side of the
guard as shown.
Location of the Scrollsaw
Please note: For best results the scrollsaw should be placed on a
flat, level surface, ideally a suitable workbench with a minimum
worktop thickness of 25 mm and fixed to the bench worktop
using the 4 holes in the base of the machine as shown in Fig 7.4.
Fig 7.1
Dust blower pipe
loose end
Fig 7.3
Blade guard
Drop foot
fixing pole
Fig 7.4
Fig 7.2
Drop foot
fixing pole
Dust blower
pipe
Bellows
cap
i
Kg
SS16V Manual 4.0 (54100, 54101, 54102) 4.0.indd 8 10/09/2015 11:17