To Next Page
J
Jeffrey LopezJul 31, 2025
What to do if the blade on my Record Power Saw won't cut wood?
- CCrystal Moreno MDJul 31, 2025
If the blade of your Record Power Saw will not cut the wood, make sure the blade isn't upside down or back to front.
What to do if the blade on my Record Power Saw won't cut wood?
If the blade of your Record Power Saw will not cut the wood, make sure the blade isn't upside down or back to front.
Why won't my Record Power BS12 Saw cut in a straight line?
If your Record Power Saw won't cut in a straight line, several factors could be the cause. It might be due to a worn blade, in which case you should change it. The guide carrier may be set too high, so adjust it accordingly. The blade tension might be incorrect; refer to the manual for instructions. The fence could be misaligned, requiring adjustment. Lastly, the table might not be aligned correctly; undo the four bolts holding the table to the trunnion and realign the table.
Why does the motor slow down on my Record Power Saw when cutting wood?
If the motor of your Record Power Saw slows down when wood is put through, it could be due to several reasons. You might be applying too much pressure to the work piece, consider reducing the force. The drive belt could be slipping, so adjust it. A misaligned fence can also cause this issue, so make sure to adjust the fence. Another potential cause is an incorrectly aligned table; undo the four bolts holding the table to the trunnion and align the table. Finally, ensure you are using the correct type of blade; if not, change the blade.
What to do if my Record Power BS12 Saw buzzes but won't run?
If your Record Power Saw machine buzzes but will not run, the issue may stem from a faulty capacitor on the motor, requiring a capacitor replacement. Alternatively, there could be a fault within the motor itself, in which case you should have the motor inspected and replaced if necessary.
Why does my Record Power Saw stop when I release the power button?
If your Record Power Saw stops when you release the on/off button, it indicates a faulty switch. You will need to change the switch.
What to do if I cannot tension the blade on my Record Power BS12?
If you cannot tension the blade on your Record Power Saw and it runs out of thread when it is on, check that you have the correct blade length.
Details the 5-year guarantee terms, conditions, and exclusions for product defects.
Provides step-by-step instructions for assembling the stand structure of the bandsaw.
Guides the user through the assembly of the wheel kit, including attaching wheels and handle.
Guides on how to tension the bandsaw blade correctly using the tensioning knob and deflection check.
Instructions on how to track the bandsaw blade on the bandwheel using the tracking knob.
Details how to adjust the upper blade roller guides and support roller for proper blade alignment.
Explains how to adjust the lower blade guides, side guides, and thrust bearing for optimal support.
Instructions on adjusting the cutting height for maximum guarding and blade support.
Guides on how to adjust the drive belt tension using the belt tensioning handle.
Explains how to change the bandsaw blade speed by repositioning the drive belt on pulleys.
Covers fundamental techniques for bandsawing, including feeding, holding, and blade selection.
Detailed steps for safely removing and fitting a new bandsaw blade, including guide adjustments.
General| Type | Bandsaw |
|---|---|
| Blade Length | 1630 mm |
| Motor Power | 370 W |
| Table Size | 300 x 300 mm |
| Weight | 22 kg |
