30
13. Dust Extraction
The Importance Of Dust Extraction
Before the machine is started, ensure that adequate dust
extraction provisions have been installed. Dust extraction
is extremely important not only for health and safety but
also for the correct upkeep of the machine. Saw dust can
cause the machine not to operate properly or even fail
completely. By keeping the machine free of large amounts
of waste the performance will be optimised.
If a large amounts of MDF or toxic woods are to be cut we
recommend that there is a good ventilation system in place
and that a particle mask is worn as minimum protection.
Record Power Extractors
Record Power offer a range of high quality dust extractors,
starting at the single motor 45 litre RSDE1 right up to the
200 litre twin motor DX5000. We offer both drum and
bag type extractors high filtration models filter down 0.5
micron providing protection from harmful fine dusts such
as MDF. Chip collectors filter down to 5 micron. All Record
Power dust extractors & chip collectors have 100mm inlets
and hoses.
DX1000 High Filtration Dust Extractor
Drum type extractor, 45 litre capacity, single 1kw motor,
suitable for intermittent use i.e must be switched off for 20
minutes every hour.
0.5 micron filtration; suitable for MDF
RSDE1 High Filtration Dust Extractor
Drum type extractor, 45 litre capacity, single 1kw motor,
suitable for intermittent use i.e must be switched off for 20
minutes every hour.
0.5 micron filtration; suitable for MDF
RSDE2 High Filtration Dust Extractor
Drum type extractor, 50 litre capacity, single 1kw motor,
suitable for intermittent use i.e must be switched off for 20
minutes every hour.
0.5 micron filtration; suitable for MDF
DX4000 High Filtration Dust Extractor
Drum type extractor, 80 litre capacity, Twin 1kw motor,
suitable for heavy usage i.e if one motor is switched
off for 20 minutes then the other can be used thus
enabling continuous usage. Or both motors can be used
simultaneously giving maximum suction but in this mode
the extractor must be switched off for 20 minutes every
hour. 0.5 micron filtration; suitable for MDF
DX5000 High Filtration Dust Extractor
Bag type extractor, 200 litre capacity, Twin 1kw motor,
suitable for heavy usage i.e if one motor is switched
off for 20 minutes then the other can be used thus
enabling continuous usage. Or both motors can be used
simultaneously giving maximum suction but in this mode
the extractor must be switched off for 20 minutes every
hour. 0.5 micron filtration; suitable for MDF
CX2600 Chip Collector
Large capacity chip collector, with a powerful 0.37kw
induction motor. An extremely smooth running unit suitable
for continuous usage. Very quiet impeller system extracts
dust and chippings. 5 micron filtration; unsuitable
for MDF
CX3000 Chip Collector
Larger capacity chip collector, with a more powerful
0.75kw induction motor and heavy duty construction. An
extremely smooth running unit suitable for continuous
usage. Very quiet impeller system extracts dust and
chippings.
5 micron filtration; unsuitable for MDF
Air Cleaners
It is strongly advised to also use an air cleaner to remove
the fine airborne dust present in the workshop which
cannot be removed using machine extraction. Record
Power offer a range of air cleaners suitable for all home
workshops. Please contact your preferred stockist, call us
on 01246 561 520 or visit www.recordpower.co.uk
for full details.
To Next Page
Loading...
