What to do if the blade cannot be properly positioned on the bandwheels of my Record Power BS400 Premium Saw?
If the blade cannot be properly positioned on the bandwheels of your Record Power Saw, adjust the blade tracking knob. Replace the blade if it is of poor quality. If the wheels are not in alignment, contact your local dealer for repair.
What to do if my Record Power BS400 Premium Saw doesn't work when switched on?
If your Record Power Saw doesn't work, first check the cable for any breakage. Also, ensure that both doors are fully closed. If these steps don't resolve the issue, the switch may be defective, requiring repair by your local dealer.
Why does my Record Power Saw blade not cut in a straight line?
If your Record Power Saw blade isn't cutting straight, make sure you're using the fence. Avoid feeding the workpiece too quickly and ensure the blade isn't bending. Check if the blade teeth are dull or damaged and replace the blade if needed. Also, ensure that the blade guides are suitably adjusted.
Why does my Record Power Saw blade not cut or cut very slowly?
If the blade on your Record Power Saw is not cutting or cutting very slowly, it might be dull from cutting hard material or prolonged use. Replace the blade, using a 6 TPI blade for wood and soft materials, or a 14 TPI blade for harder materials. Also, ensure the blade is fitted correctly.
What to do if the blade of my Record Power BS400 Premium doesn't move when the motor is running?
If the blade on your Record Power Saw isn't moving while the motor is running, switch off the motor and check that the quick release lever or blade tension wheel is tightened. If the blade has come off one of the wheels, refit the blade, track, and tension it. Also, inspect the blade and the drive belt; replace them if either is broken.
Guidelines for safe use, including personal protective equipment and appropriate attire.
Pre-operation checks and safe working practices during machining.
Specific safety precautions for bandsaw operation, including blade handling.
Essential checks before starting the bandsaw, like blade tension and guides.
Steps for fitting the table, fence bar, and scale to the bandsaw.
Adjusting the table stop for a 90-degree angle to the blade.
How to properly tension the bandsaw blade for optimal cutting.
Adjusting the blade to run centrally on the bandwheels.
Setting the upper blade guides and thrust bearing for blade support.
Setting the lower blade guides and thrust bearing for blade support.
Fundamental techniques and safety for bandsawing.
Procedures for safely restarting the machine after interruptions.
Criteria and recommendations for choosing the right blade for materials.
Why dust extraction is crucial for health, safety, and machine longevity.
List of common issues and their probable causes.
Solutions and recommended actions for common machine problems.
General| Power | 1500W |
|---|---|
| Dust Extraction Outlet | 100 mm |
| Voltage | 230V |
| Table Tilt | 0 to 45 degrees |
| Blade Diameter | 400mm |
To Next Page