6. Stand & Wheelkit Assembly - Cont.
8
Stand Assembly
1. Locate the four legs (E) and secure them to the upper
frame (A) using the nuts, bolts and washers supplied.
2. Locating holes a third of the way down each leg are for
securing the long mid brace supports (C). Fix the long
mid brace supports to the frame using the nuts, bolts
and washers.
3. Finally, fit the two short mid brace support (D) to the
shorter sides of the stand and position the frame
upright. Once the frame is upright, the whole assembly
should fall into place. All fixings should now be fully
tightened.
Note:
When assembling this legstand Do Not fully tighten
the nuts and bolts until the assembly is complete.
Finger tight should be sufficient.
A
E
C
D
To Next Page
Loading...
