Record Power WG200 - 10.5 WG250;E Scissor Jig

24
10.5. WG250/E Scissor Jig
Use to sharpen:
• Scissors
• Garden shears
The scissor jig mounts on to the support arm of the wet stone sharpener.
A Clamp
B Clamp knob
C Scissor holder
D Support plate
E Depth screw
Using the Scissor Jig
Adjust the depth screw to allow the scissor blade to be placed in the clamp
as shown in Fig 10.5.1 and tighten the depth screw and clamp knob.
Secure the scissor blade in the clamp as shown in Fig 10.5.2 so the bevelled
edge is facing the rear of the jig.
Mount the support arm in the upper position.
Slide the support plate onto the support arm as shown in Fig 10.5.3 and
secure in position at an angle that allows the bevelled edge of the blade to
come into full contact with the stone as shown in Fig 10.5.4.
B C DA
E
Fig 10.5.1
Fig 10.5.2
Fig 10.5.3
Fig 10.5.4
Sharpening stone
Scissor
blade
Jig