Record Power WG200 - WG250;F Side Wheel Sharpening Jig

25
10.5. WG250/E Scissor Jig
Fig 10.5.5
10.6. WG250/F Side Wheel Sharpening Jig
Use to sharpen cabinet scrapers
The side jig mounts on to the support arm of the wet stone sharpener and
allows grinding against the side of the sharpening stone. It must be used in
conjunction with the WG250/I Tool Rest Jig.
A Support arm
B Locking knob
Fig 10.6.1
Fig 10.6.2
BA
Using the Side Jig
Mount the support arm in the side position, attach the jig as shown in Fig
10.6.1 and secure in place with the lock knobs.
Attach the WG250/I Tool Rest Jig as shown in Fig 10.6.2 at 90º to the side
of the stone and sharpen as shown.
Pass the blade across the stone to sharpen the bevelled edge, tilting the jig if
necessary to follow the curve of the blade, Fig 10.5.5.
Carry out the above procedure for both blades of the scissors.
Both clamps may need to be used for holding longer blades such as garden
shears.