Record Power WG200 - WG250;I Tool Rest Jig

28
10.9. WG250/I Tool Rest Jig
Use to sharpen:
• Woodturning scraper chisels
• Screwdrivers
• Cabinet scrapers
• Hollowing tools
• Spoke shave blades
The tool rest jig mounts onto the support arm of the wet stone sharpener in
either the upper or lower position.
A Lock knob
B Face
Fig 10.9.1
A
B
Using the Tool Rest Jig
Mount the support arm in the side position.
Slide the tool rest jig on to the support arm and fix in place with the lock
knob as shown in Fig 10.9.1.
The required angle can be set using the position of the support arm and of
the jig itself.
Rest the tool on the jig and apply to the sharpening stone as shown in
Fig 10.9.1.