Parameter explanations V2.1_V2.6
2
IRA_B8_EN_2V2_REC_102-020401137 17/ 56
Input/Output → STG →
SÖK:NSK → Speed
30
Miscellaneous → Alarm display
→ Time activation
0
→ CO48 Sandow direct Door with integrated rubber cord (power storage).
▪ For 108/150 mm drives
▪ Only for motors with brake
▪ In France no batteries are allowed
▪ Default parameters:
Parameter Default value
Driving cycle → Close → Hold-
ing force
40
Drive → Brake Open/Close-Position
Drive → Power failure Emergency operation
Input/Output → STG →
AUX1_IN
Broken rubber cord
→ Basic escape route Escape route door for GB with special battery surveillance.
▪ Only allowed with lead-acid battery (British standard).
▪ With
Parameter → Battery Emergency operation
only set-
tings in opening direction are possible.
▪ Battery operation cannot be configured, after a power fail-
ure an emergency opening always occurs according to pa-
rameter
Battery emergency operation
. Once mains voltage
is back, it changes automatically back to the previous op-
erating mode.
▪ The battery is tested once per minute. Should the battery
be defective or insufficiently charged, an emergency open-
ing according to
Parameter → EmergOp Battery
is carried
out, even in case of available mains voltage. Returning to
normal operation is only possible with a new start via
EMERGENCY STOP or FPC902.
Parameter Default value
Drive → Power failure Emergency operation
Drive → Battery Lead
→ Folding door Australia Folding door for Australia with special driving behaviours.
▪ Different driving behaviours
▪ Higher opening and closing speed
In some ways different behaviour after stop and collision
To Next Page
Loading...
