COPYRIGHT © 2013 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.1, REV-D | 82
be used as guides for proper temperature calibration.
ADAPTIVE
Select a target temperature and the bottom fan self-adjusts to maintain the selected temperature. The default
target temperature is 65 °C. This is the default mode for EPIC DRAGON and SCARLET DRAGON.
After the camera reaches the target temperature, and if the ambient temperature remains constant, Adaptive
mode results in a consistent fan speed and fan noise over time.
Targeting a higher temperature raises the sensor temperature, lengthens the sensor warm-up time, and lowers
the fan speed. Targeting a lower temperature lowers the sensor temperature, shortens the sensor warm-up
time, and increases the fan speed.
EPIC DRAGON and SCARLET DRAGON: Target temperature range is 55–70 °C. A target temperature of 65 °C
works best across most environmental conditions.
EPIC MYSTERIUM-X and SCARLET MYSTERIUM-X: Target temperature range is 45–70 °C. Target temperatures
above 50°C will give noticeable fan noise improvements when compared to Auto mode.
ADAPTIVE PREVIEW QUIET RECORD
Select a maximum bottom fan record speed, and the standby mode fan speed self-adjusts accordingly so that
enough cooling is provided overall. This mode maintains a lower fan noise level than Auto mode during record-
ing.
The default Maximum Record Speed is 50%. The Maximum Record Speed range is 25–100%. A slower speed
setting results in a faster standby mode fan speed, and vice versa.
NOTE: The maximum speeds are intended as target speeds only; actual fan speeds may at times be higher than
specified to satisfy any unmet cooling requirements due to long recording times or high ambient temperatures.
AUTO
This is the default mode for EPIC MYSTERIUM-X and SCARLET MYSTERIUM-X cameras.
Select a maximum bottom fan record speed, and the standby mode fan speed self-adjusts accordingly so that
enough cooling is provided overall.
The default Maximum Record Speed is 50%. The Maximum Record Speed range is 25–100%. A slower speed
setting results in a faster standby mode fan speed, and vice versa.
NOTE: The maximum speeds are intended as target speeds only; actual fan speeds may at times be higher than
specified to satisfy any unmet cooling requirements due to long recording times or high ambient temperatures.
To Next Page
Loading...
