RED DSMC OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC
955-0020_V5.1, REV-D | 83
QUIET
The bottom fan self-adjusts to maintain the lowest possible noise level in record and standby mode while still
cooling the DSMC. Using Quiet results in a higher sensor temperature when compared to Auto mode.
NOTE: In v5.1.14, this fan mode was called “Quiet Preview and Record”.
MANUAL
Select a speed for the bottom fan in both record and standby modes. The bottom fan self-adjusts to maintain
the selected speeds. The default Maximum Record Speed is 50% and the default Maximum Standby Speed is
75%. The range for both Maximum Record Speed and Maximum Standby Speed is 25–100%.
NOTE: The maximum speeds are intended as target speeds only; actual fan speeds may at times be higher than
specified to satisfy any unmet cooling requirements due to long recording times or high ambient temperatures.
POST RECORD DELAY
Select the amount of time that it takes for the bottom fan to switch from record to standby mode. Default is
None.
LENS
LENS TAB
The options you see on the Lens tab change based on the lens mount that’s currently attached.
PL MOUNT
Auto-Detect PL Lenses: By default, this feature is disabled.
Detect Lens
CANON AND NIKON LENS SETTINGS
The settings below display when a DSMC Nikon Mount, DSMC Canon Mount, or DSMC Canon MOTION MOUNT
is installed with a supported lens.
Aperture: Enter the F-stop value. The range and default depend on the attached lens.
Focus: Enter the focal distance. The default value is the value read from the lens. The range depends on
the attached lens.
MOTION MOUNT TAB
NOTE: The Motion Mount menu is only accessible when a DSMC
®
RED MOTION MOUNT
TM
is installed. For more
information about using the MOTION MOUNT, see the DSMC MOTION MOUNT Operation Guide, available at
www.red.com/downloads.
1. Navigate to Settings > Setup > Lens > Motion Mount.
2. Select one of the following Motion Mount settings from the Shutter Type drop-down menu:
‒ ND Only: The MOTION MOUNT functions only as an ND filter.
‒ Soft: The MOTION MOUNT soft shutter takes over shuttering duties, and the MOTION MOUNT contin-
ues to function as an ND filter.
‒ Square: The MOTION MOUNT square shutter takes over shuttering duties, and the MOTION MOUNT
To Next Page
Loading...
