31
Analog Output Parameters
-
PAXI only
Serial Communication Parameters
-
PAXI only
DISPLAY PARAMETER
FACTORY
SETTING
USER SETTING
BAUD RATE
DATA BIT
PARITY BIT
METER ADDRESS
ABBREVIATED PRINTING
PRINT RATE
PRINT COUNTER A
PRINT COUNT LOAD VALUES
PRINT MAX & MIN
PRINT COUNTER B
PRINT COUNTER C
PRINT SETPOINT VALUES
PARAMETER
FACTORY
SETTING
USER SETTING
ANALOG ASSIGNMENT
ANALOG LOW SCALE VALUE
ANALOG HIGH SCALE VALUE
ANALOG TYPE
DISPLAY
USER SETTING
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
SETPOINT HYSTERESIS (rate)
SETPOINT ASSIGNMENT
USER SETTING
RESET WHEN SPn+1 DEACTIVATES
RESET WHEN SPn+1 ACTIVATES
SETPOINT RESET WITH DISPLAY
COUNTER AUTO RESET ACTION
SETPOINT TIME OUT
SETPOINT ON DELAY
SETPOINT VALUE (B)*
SETPOINT OFF DELAY
SETPOINT VALUE (A)
STANDBY OPERATION
SETPOINT ACTION
SETPOINT BOUNDARY TYPE
SETPOINT POWER UP STATE
SETPOINT OUTPUT LOGIC
SETPOINT TRACKING
SETPOINT ANNUNCIATORS
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
PARAMETERDISPLAY
Setpoint (Alarm) Parameters
PRINT SCALE FACTORS
* See Module 2, Exchanging Parameter Lists, for details on programming this value.
Shaded areas are model dependent.
Factory Service Parameters
LIMITED WARRANTY
The Company warrants the products it manufactures against defects in materials and workmanship for
a period limited to two years from the date of shipment, provided the products have been stored,
handled, installed, and used under proper conditions. The Company’s liability under this limited
warranty shall extend only to the repair or replacement of a defective product, at The Company’s
option. The Company disclaims all liability for any affirmation, promise or representation with respect
to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify RLC against
damages, claims, and expenses arising out of subsequent sales of RLC products or products containing
components manufactured by RLC and based upon personal injuries, deaths, property damage, lost
profits, and other matters which Buyer, its employees, or sub-contractors are or may be to any extent
liable, including without limitation penalties imposed by the Consumer Product Safety Act (P.L.
92-573) and liability imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L.
93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products except those
expressly contained herein. The Customer acknowledges the disclaimers and limitations contained
herein and relies on no other warranties or affirmations.
DISPLAY
DISPLAY INTENSITY LEVEL
FACTORY
SETTING
USER SETTINGPARAMETER
To Next Page
Loading...
