-31-
Released 2018-01-12 Drawing No. LP0932
-C
COMUNICATIONS
TYPE
BAUD
RATE
DATA
BIT
PARITY
BIT
UNIT
ADDRESS
P
P
2400 9600
400 19k2
3k4
NO VN Odd
Set the baud rate to match that of other serial communications
equipment. Normally, the baud rate is set to the highest value that all of
the serial communications equipment is capable of transmitting.
Select either 7 or 8 bit data word lengths. Set the word length to match
that of other serial communication equipment. If r is selected as the
communication type, dAA defaults to 8.
Set the parity bit to match that of the other serial communications
equipment used.
1 to 24
Select a Unit Address that does not match an address number of any
other device on the serial link.
r ModBus RTU
AC ModBus ASCII
Select the desired communications protocol.
r
YP
3k4
bAd
dAA
NO
PArb
24
Addr