Red Sea MAX User Manual
1.
2.
3.
4.
5.
6.
7.
Remove the light tubes, cardboard box and packaging
materials from inside the tank.
and that the power center can be removed from its niche. Be
certain that the area surrounding the aquarium is waterproof,
and consider moving away anything that water might
damage.
With one person positioned at either side of the tank,
grasp the aquarium's top rim and lift it gently out of the
box and onto a flat surface.
Room temperature
Open the inner cardboard box and remove all of the parts.
Read the Pre-Operating Instructions before assembling.
The site selection may affect proper temperature
maintenance. It is recommended to keep ambient
temperature within the same range as a healthy tank (24-
27°C / 76-83°F) to facilitate proper temperature parameters.
Avoid placing the tank in front of an air conditioner, heating
vents or direct sunlight. A well ventilated room with moderate
light is the best place to position the aquarium.
Unpacking the aquarium
Please read this section carefully before proceeding. Note that
the empty aquarium weighs approximately 25kg (55lbs);
therefore two people are required to move it.
To unpack the aquarium
Remove the protective packaging from around the hood.
Remove the hinge pins from either side of the hood
opening and set aside.
Holding your hand under the hood from the middle of the
opening, lift the hood and gently place it aside for later
assembly.
8