Red Sea MAX User Manual

Red Sea MAX User Manual
3. Insert the direction nozzle into the pump outlet through
the hole. Ensure that the two components are securely
attached so the pump does not move when you wiggle
the nozzle.
Figure 6: Installing circulation pumps
4.
5.
1.
2.
3.
Place the pump's electrical cord in the cord channel that
runs the length of the aquarium's back rim, threading it
through the outermost cord channel at the other end of
the aquarium and out through the cord access hole.
Repeat steps 1-4 for the second pump, attaching it to the
other nozzle through the remaining hole in the smoked
glass wall, and threading the cord through the middle cord
channel at the other end of the tank.
Heater
Inspect the heater for damage
or cracks.
Set the thermostat to
approximately 26°C (79°F).
Insert the heater into the small
heater chamber, which is
adjacent to the filter media
chamber.
Figure 7: Heater
4.
5.
Attach the heater securely to
the wall using the suction cup
provided.
Thread the heater cord
through the channel to the
other end of the tank,
threading it through the
innermost of the three
channels at the other end and
out through the cord access
hole.
Figure 8: Threading the
heater cord
Cable channel covers
With the three cables from the circulation pumps and heater
held in the cable channel, snap the left cable channel cover
first and then the right cable channel cover into position.
10

Red Sea MAX Specifications

General

Type	Aquarium
Sizes	Various
Filtration	Integrated
Lighting	LED
Heater	Included
Protein Skimmer	Included
Circulation Pump	Included