USING THE AC POWER
Start your REDBACK Generator as per the instructions in
the ‘STARTING YOUR GENERATOR’ section.
Let your REDBACK Generator run for a short while. Once
the digital
display
y
shows 240v, your REDBACK Generator is
ready to be used.
Ensure your equipment is turned off before connecting to the AC outlets.
USING THE DC POWER
When using AC, DC can be used simultaneously.
A DC surge may cause the DC protection switch to depress. If this happens,
press the DC Protection button located on the Control Panel.
15
WARNING! The DC outlet is for charging 12v batteries only, note that the battery
charging outlets IS NOT regulated. You must monitor the battery voltage. If the
voltage exceeds 14v you must immediately disconnect the battery. Failure to do
so can result in overcharge and may cause fire or explosion.
Connect the alligator clips first and then insert the ‘T’ plug into your REDBACK
Inventor Generator.
If charging a car battery, ensure the battery is disconnected from your car. DO
NOT starts your car while the charging cable is connected. Doing so will damage
your REDBACK Inventor Generator.
DO NOT cross the polarity of the cables, doing so can damage your REDBACK
Inventor Generator.
Ensure battery charging is done in a dry, safe, ventilated are away from the
hazards or flammable liquids and / or gases.
In the unlikely event battery acid comes in contact with skin or eyes immediately
go to hospital and see a doctor.
All manuals and user guides at all-guides.com
To Next Page
Loading...