CHANGING THE OIL
Oil Filler Cap
Oil Discharge Pipe
1.
Using the screwdriver provided loosen the 2 screws and open the oil/
service /air filter access panel.
2.
Unscrew the oil filler cap and remove.
3.
Screen the oil discharge pipe into the oil reservoir and tighten.
4.
Tilt your REDBACK Generator forward and pour the oil into a
suitable container.
5.
Using the oil container provided, fill the REDBACK
Generator with 450mI of 10W30 oil.
6.
Unscrew and remove the oil discharge pipe.
7.
Refit the oil filler cap and tighten finger tight.
8.
Tilt your REDBACK Generator side to side a few times to ensure
that the oil alarm float is level,
9.
Refit the oil/ service /air filter access panel, using the screwdriver
provided tighten the 2 screws.
19
WARNING! If engine is hot, oil can discharge quickly.
Ensure engine is switched off and the fuel tap is in the ‘off’ position.
To Next Page
Loading...