Reebok Competitor RT5.1 - The Upright Wire

8
2. See the inset drawing. Cut the plastic tie near
the Upright Wire (88).
Attach a Wheel (93) to the Base (91) with a 3/8"
x 2" Bolt (9) and a 3/8" Nut (10). Do not over-
tighten the Nut; the Wheel must turn freely.
Press a Base Cap (110) into the Base (91).
91
9
10
2
93
110
Plastic Tie
Cut
88
3. Identify the Right Upright (81), which is marked
with a “Right” sticker. Hold the Right Upright
near the Base (91) as shown.
See the inset drawing. Tie the wire tie in the
Right Upright (81) securely around the end of
the Upright Wire (88). Then, pull the other end
of the wire tie until the Upright Wire is routed
through the Right Upright.
Wire Tie
88
81
91
88
3
Wire
Tie
81
88