reedinstrume nts
w ww
c om
7
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Only if you REALLY need them:
Pantone 534 Blue - 100/80/30/5
Pantone 485 Red - 10/100/100/5
Pantone 123 Yellow - 0/27/100/
INSTRUMENTS
Operating Instructions
1. Set up the datalogger using the software provided.
See “Datalogging Software” section for more information.
2. Connect the voltage test leads or the current probes to the AC
source, or clamp the jaws around a single conductor for AC cur-
rent measurements up to 200A.
3. Press and Hold the START/STOP button for four seconds to start
recording. The REC icon will appear in the display indicating that
recording has begun.
4. Press and Hold the START/STOP button for four seconds to stop
recording. The REC icon will disappear from the display.
5. Remove the probe, connect the datalogger to a PC and use the
supplied software to download the data.
Note: If the clock is not set to the correct time, you may need to replace
the 3V button battery.
MAX/MIN
While taking a measurement, press the MAX/MIN button once to display
the MAX (maximum) reading. Press the button again to display the MIN
(minimum) reading. A third press will exit MAX/MIN mode. The meter will
automatically exit MAX/MIN mode in 10 seconds if no button is pressed.
Auto Power Off
This meter will automatically shut off after 5 mins of inactivity. Auto Power
Off does not apply when recording.
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.ca
To Next Page
Loading...
