Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Only if you REALLY need them:
Pantone 534 Blue - 100/80/30/5
Pantone 485 Red - 10/100/100/5
Pantone 123 Yellow - 0/27/100/
INSTRUMENTS
Backlight
Press the Backlight Button to turn the LCD Backlight on and off. The
Backlight will automatically turn off after 30 seconds.
Setting the Date and Time
The internal clock is run by an internal rechargeable battery. The battery is
charged by the main unit’s battery and will continue to run for 30 minutes
after the main unit batteries have been removed or have run out.
1. While the meter is off, enter the SETUP mode by pressing and
holding the Setup Button and turning the meter on.
2. “SEt” will appear on the LCD. Press the Clock Button to select the
clock setting function.
3. Press the Up and Down arrows to adjust the year. Press the Clock
button to save and move to the next values, which are Month,
Day, Hour, Minute, and Second.
4. Press the Clock button again to save and exit Clock Setup. Press
the Power Button at any time to cancel and exit.
Data Logging
1. Turn the meter on and select the Response Time and Frequency
Weighting for your measurements.
2. Press the Record Button to begin Data Logging the measured
values.
3. Press the Record Button again to stop Data Logging. When the
internal memory is full, the LCD will display “FULL”.
1.888.475.5235info@REED-Direct.com
REED-Direct.com
To Next Page
Loading...
