58
Attentions:
• The aircraft cannot avoid obstacles when it is ying back during the RTH process.
• The aircraft cannot return to the Return Point if the GPS signal is weak or unavailable.
• During RTH process, when the aircraft is ying above 30 meters, the aircraft will immediately perform the RTH
function; when ying below 30 meters, the aircraft will rise to 30 meters automatically and then perform the RTH
function.
• If the aircraft does not receive the satellite signal or the signal of the remote controller continues to be lost for more
than 2 seconds, the aircraft will not be able to return, and will slowly descend until it lands.
5.4 Aircraft LEDs And Status Indicator
a b
a. Vision Positioning Status Indicator - LED
Flashing red light Vision positioning failure
Solid red light In vision positioning
b. Flight Status Indicator - LED
Solid blue light on start-up Self-inspection
Solid green light RC and aircraft is paired, GPS is located
Flashing green light RC and aircraft is paired, GPS is not located
Red and blue light ashing alternately Horizontal calibration process
Red and green light ashing alternately Vertical calibration process
Flashing blue light RC and aircraft is not paired, GPS is not located
Solid blue light RC and aircraft is not paired, GPS is located
Solid red light Serious error
To Next Page
Loading...