Reely 2346659 - Drone Flight Operations; Flight Environment and Restrictions; Pre-Flight Inspections

71
7. Flight
7.1 Flight Environment Requirements
• Do not y the drone in bad weather such as high winds, snow, rain, foggy weather, etc.
• Choose a wide, open place with no tall buildings surrounded as a ight site. Buildings that use a lot of steel bars
may affect the compass work and block GPS signals resulting in poor positioning or even inability to locate the
drone.
• When ying, please keep drone in sight, away from obstacles, crowds, water, etc.
• Do not y in areas that have high-voltage lines, communication base stations or transmission towers, etc. to avoid
signal interference of the remote controller.
• When ying above 5000m altitude, the performance of the drone battery and power system will be degraded due
to environmental factors, thus the ight performance will be affected. Please y with caution.
• GPS is not available for ight in Arctic Circle and Antarctic Circle.
7.2 Flight Restrictions and Flight Limits of Special Area
According to the air trafc control regulations and the drone management regulations of ICAO and different nations’
air trafc control, drones must y in the prescribed airspace.
7.3 Pre-Flight Inspection
• Make sure the remote controller, drone battery, and mobile device are fully charged;
• Make sure the propellers intact and installed correctly;
• Make sure that front and rear arms and the blades are fully unfolded;
• Make sure that the camera lens is clean;
• Make sure the microSD card is installed correctly;
• Ensure that the battery is rmly installed;
• Always use original components or accessories certied by the Manufacturer. The use of non-original accessories
may pose a hazard to the use of the drone.