What to do if there is an OSSD output error on Reer Controller?
If you encounter an OSSD output error with your Reer Controller, begin by checking the OSSD1/2 connections. If the problem continues, try restarting the system. Should the issue persist after these steps, it is recommended to return the M1 to ReeR for repair.
What to do if Reer MOSAIC MR2 shows an error in communication with slave?
If the Reer Controller displays an error in communication with a slave, the first step is to restart the system. If restarting doesn't resolve the issue, the next step is to return the M1 to ReeR for repair.
What to do if my Reer MOSAIC MR2 Controller displays an MCM error?
If you're facing an MCM error with your Reer Controller, start by restarting the system. If the problem persists after the restart, return the M1 to ReeR to be repaired.
How to fix a slave unit error on Reer MOSAIC MR2 Controller?
If you encounter a slave unit error with your Reer Controller, first check which unit is in FAIL mode. If identifying the failing unit doesn't resolve the problem, replace the MCM.
General| Type | Safety controller |
|---|---|
| Operating Voltage | 24 VDC |
| Protection Rating | IP20 |
| Safety Standards | EN ISO 13849-1 |
| Number of Safety Outputs | Up to 16 |
| Communication Interfaces | Ethernet |
| Safety Integrity Level | SIL3 |
To Next Page
