GB
Range control
ECO mode
This baby monitor is equipped with an optical and acoustic range control system. At
regular intervals, check the baby unit and the parent unit for two-way communication
(also in standby mode, if the baby unit is not receiving any noise). If the range is exceeded,
the status LED on the parent unit begins to ash red and an alarm tone sounds at regular
intervals.
As soon as you place the parent unit at a xed site at which you have checked reception on
a previous occasion, we recommend that you switch ECO mode on. IIn ECO mode, range
control is switched o and therefore in standby mode (whenever your child is quiet) the
baby unit does not emit any radiation. The baby unit then goes to send only when noises
are received.
As soon as the batteries are too weak, the status LED in the switched on state begins to
ash red. If the device is not connected to a power supply, the connection will worsen
and eventually cut o automatically. Rechargeable batteries can be charged directly in the
baby monitor. To do this, connect the device to the wall power supply using the supplied
mains adapter. The batteries take approximately 10 hours to charge (with the device
switched o).
Battery operation
Volume control / parent unit
To increase or decrease the receiver volume on the parent unit, press + (for louder) or - (for
down).
19
To Next Page
Loading...
