Troubleshooting
The status LED does not light up
Make sure that both units are switched on.
Check the connection of the mains adapter to the wall power socket and the unit.
Exchange the batteries and/or check the polarity.
The status LED ashes orange
The parent unit receives sounds. Turn up the volume on the parent unit to make sure
that you hear the sounds from your baby.
The status LED flashes red
Long flashing: Batteries are flat. Replace the batteries or connect the unit to the power
supply.
Short flashing: maximum range is exceeded. Reduce the distance between the baby and
parent unit.
No sound transmission despite established connection
The volume is set too low. Turn the volume control on the parent unit up.
The microphone sensitivity is set too low. Turn the microphone sensitivity control on the
baby unit up.
22
To Next Page
Loading...
