Reflex EZ-TRAC Field Guide

Enter desired Toolface
18. Enter your required Toolface setting (e.g. 90). When
finished, highlight CONTINUE and press OK.
19. a) Rotate the rods clockwise by the amount
displayed.
b) To verify the toolface by a new measurement,
highlight RE-MEASURE and press OK. Repeat
step from step 12.
c) To return to the ORIENTATION menu, highlight
BACK and press OK two times. Go to step 17.
19

Reflex EZ-TRAC Specifications

General

Brand	Reflex
Model	EZ-TRAC
Category	Measuring Instruments
Language	English