To Next PageTo Next Page
Need help?Do you have a question about the Reftek REF TEK 130-GPS and is the answer not in the manual?
General| Brand | Reftek |
|---|---|
| Model | REF TEK 130-GPS |
| Category | Measuring Instruments |
| Language | English |
Provides a general overview of the REF TEK 130-GPS clock system.
Covers general procedures for setting up and operating the REF TEK 130-GPS clock.
Details how to mount the GPS unit for optimal signal reception.
Explains how to tape the PTO connector to prevent static discharge.
Outlines guidelines for mounting the GPS unit for best satellite signal.
General guidelines for mounting the GPS unit for optimal signal.
Specific steps for mounting the GPS unit on a pole.
Details the procedure for permanently mounting the GPS unit using a U-bolt.
Describes how to temporarily mount the GPS unit using a tie-wrap.
Explains how to place the GPS unit on the ground for optimal reception.
Introduces the REF TEK 130-GPS clock with a Garmin™ 15H/L GPS module.
Lists the technical specifications for the Garmin™ GPS module.
Details the time base characteristics of the GPS receiver.
Describes the main components of the 130-GPS system.
Provides an assembly drawing and notes for the 130-GPS unit.
Details the upgrade procedure for the 130-GPS system.
Provides technical information on the RT552 GPS time board.
Explains the main functions of the RT552 GPS interface board.
Shows the component and solder side views of the RT552 board assembly.
Describes the electronic operations and capabilities of the RT552 receiver board.
Overviews the 130-GPS clock with an integrated Garmin™ receiver.
Lists specifications for the integrated GPS unit.
Details the time base characteristics of the integrated GPS.
Instructions for changing the GPS unit mounting for ground placement.
Describes the electronic operations of the 130-GPS with integrated receiver.
Outlines the procedure for obtaining warranty and non-warranty service.
Provides warnings and guidelines for handling static-sensitive circuit boards.
