Need help?Do you have a question about the Rega fono mm and is the answer not in the manual?
General| Input Loading | 47kΩ in parallel with 100pF |
|---|---|
| Gain | 41.4dB at 1kHz |
| Output Impedance | 100Ω |
| Recommended Minimum Output Load Impedance | 5kΩ |
| Power Requirements | 24V AC |
| Type | Phono stage |
| Signal to Noise Ratio | 78dB |
Details the amplifier's discrete input stage, RIAA equalization, and signal amplification for hi-fi inputs.
Turn on via the front button; the Rega logo glows RED when active.
Advised to turn on the Fono first, then the amplifier, to avoid speaker 'thump'.
Connect tonearm leads and earth to the Fono's input, and the Fono's output to the amplifier's line input.
Connect separate signal earth from turntable/tonearm to the unit's earth terminal.
Connect the Rega PS1 power supply to the AC socket on the Fono's back panel.
Details the front power button and the indicator light.
Illustrates input, output, and turntable earth connections on the rear panel.
To Next Page
