INT-15
Introduction
Capacity Plate
Close to the helm on Regal boats up to 26’ in length is a capacity
plate. A typical capacity plate for domestic vessels is shown below.
This plate represents manufacturers who participate in the National
Marine Manufacturer’s Association small boat certifi cation program.
The driver of the craft must read and understand the plate information
before operating the vessel.
The capacity plate data applies under normal conditions. Be sure to read
and abide by the capacity limits. Remember, the boat operator is
responsible for the vessel and the safety of its passengers.
Note the typical capacity plate information below:
• The plate states the maximum number of persons allowed on the
boat.
• The total weight of persons, gear and other items under normal
conditions that the boat is capable of carrying.
• Overloading, improper loading and weight distribution are well
documented causes of accidents. Provide for an extra margin of
safety in rough sea conditions.
TYPICAL EXAMPLE SHOWN
To Next Page
Loading...
