BRIDGE CLEARANCE
Be aware that your vessel requires a specifi ed bridge clearance height.
This height is a measured estimate from the waterline to the top of
the highest object usually the sport arch, radar or the masthead light
depending on what arch equipment is installed. All canvas should be
in the stored position. The estimated height can change because of
variances in the loaded condition of the vessel. Consult the bridge
clearance specifi cations located in Chapter 12 (technical information
section). An easy way to measure bridge clearance is to have someone
place a long straightedge such as a piece of wood at a 90 degree angle
across the highest point of the boat with the boat in the water. Then
with a tape rule measure the distance straight down (90 degrees) to
the waterline. Take this measurement with the fuel and water tanks
1/2 full and only 1 person besides yourself on board. This will give
you a safe measurement. As your boat is loaded down with people the
bridge clearance will be slightly lower.
Some bridges are tendered. Know and use the proper bridge signals
when approaching these bridges (see bridge signals on page 2-3). You
can also monitor and communicate on channel 13 of a VHF radio
for bridge information in most domestic locals. Other bridges are
marked with a clearance measurement and you are on your own. After
determining your vessel will clear the bridge proceed with caution at a
safe idle speed. Keep your eye on vessel traffi c at all times in order to
react quickly. Resume a safe speed once clear of the bridge structure
and acknowledgment of clear visibility.
Use common sense regarding bridge clearance because bodily injury
and property damage could result if a mishap occurs with a bridge
structure.
2-10
CHAPTER 2
To Next Page
Loading...
