DRAIN PLUG
Your boat is equipped with a drain plug centrally located on the
transom below deck level. Make sure it is installed tightly before
launching. Tighten with a wrench. Do not use your fi ngers alone to
tighten it. After your outing, while the boat is angled on the ramp,
remove the drain plug to eliminate any bilge water accumulation. If
the water stream is diminished, check for foreign objects stuck in the
drain hole. Pull the drain plug if dry storing the boat for extended
periods, especially in colder climates.
Refer to the vessel operation chapter for pre-departure use. Refer to
the storage and winterization chapter for storage information. Review
the trailering section for pre-launch and post-trip instructions.
TIGHTEN - CLOCKWISE
Drain Plug Diagram
HORN
A switch at the helm controls the audible horn signal installed on your
vessel. Be sure to test the horn before each outing and learn the horn
and bridge signals by reviewing the rules of the road chapter. Hold
the button in as needed for on-going signal.
6-20
Chapter 6
To Next Page
Loading...
