BLOWER
A switch at the helm controls the blower in the bilge. The blower must
be activated and run at least 4 minutes prior to starting the engine.
The fan cycles fresh air into the engine compartment. It is connected
to the ventilation hoses reaching the lower 1/3 of your bilge. The
blower should be operated below cruising speeds.
For safety requirements on blower use, refer to the safety on board
chapter. For switch control location, refer to the engine and controls
chapter. Refer to the systems chapter for electrical system explanations.
Refer to the vessel operation chapter for pre-departure use. Refer to
the technical chapter for sump schematics.
!
WARNING
GASOLINE VAPORS CAN EXPLODE. BEFORE STARTING THE
ENGINE, OPERATE BLOWER FOR 4 MINUTES AND CHECK THE
ENGINE COMPARTMENT FOR GASOLINE LEAKS OR VAPORS.
RUN BLOWER BELOW CRUISING SPEED.
Typical Blower
6-6
Chapter 6
To Next Page
Loading...
Need help?
General
