Bimini Top Installation:
First assemble your bimini. Slide all bows through the appropriate
sleeves on your canvas. Then attach all bows to the appropriate support
arm on the bimini. These bows attach by use of a ball and saddle
joint. Slide the ball through the saddle until it stops, then secure the
joint from behind by sliding the tethered pin through the saddle.
Next attach your bimini contraption to your boat. Use the ball
and saddle joints located on your windshield to mount you bimini
to your boat. Slide the ball through the saddle until it stops, then
secure the joint from behind by sliding the tethered pin through the
saddle. Ensure your bimini can expand forward over the helm before
continuing.
Typical Saddle Joint
From the storage position, the next step is to unzip your bimini from
the boot that encloses the canvas. The boot will need to be stored
for future storage purposes. Now unroll the canvas and extend your
bimini out over the cockpit.
The front of your bimini requires tension to prevent it from collapsing
under the designed conditions. The two straps positioned on the
forward side of the bimini should be adjusted to the appropriate
length and fastened to the camel back eye strap hardware affi xed to
your windshield. Ensure these straps tightly hold the bimini in place.
Your bimini top can now be used for recreation.
6-8
Chapter 6
To Next Page
Loading...
