To install the bow/cockpit cover:
First note that on the bow end of the cockpit cover, there
is a velcro strip used to attach to an optional bow cover.
This strip can be used to align the covers with your boat.
Simply align the velcroed edge with the windshield.
Ensure the center windshield is in the closed position. Start
snapping the cover to the deck by use of the eyelet snaps,
starting at the bow and working aft.
Notice in the middle underside of your cover, you may fi nd
an area of reinforced canvas with an eyelet snap. This snap
connects to a cockpit cover pole. This pole is adjustable,
and by opening the lock, the pole can telescope out to
the desired length. This pole should push the canvas up
when standing straight up on its rubber enclosed foot. The
purpose here is to prevent the pooling of water. The same
is true for your bow cover.
Continue snapping the cockpit cover to the deck snaps.
When you reach the rear corner, leave enough room to
allow a safe exit.
The cockpit cover and bow cover should be rolled up for storage
inside the ski locker when trailering or storing your boat. This canvas
should not be used while the engines are running, or when towing.
6-10
Chapter 6
1)
2)
3)
4)
To Next Page
Loading...
