7-42
CHAPTER 7
Checking MerCrusier Stern Drive Oil
ENVIRONMENTAL HAZARD!
DISCHARGE OF OIL OR OIL WASTE
INTO THE ENVIRONMENT IS RESTRICTED BY
LAW. DO NOT SPILL OIL OR OIL WASTE INTO THE
ENVIRONMENT WHEN USING OR SERVICING
YOUR VESSEL. DISPOSE OF OIL OR OIL WASTE
AS DEFINED BY LOCAL & STATE AUTHORITIES.
1. Drive oil level must be checked with the engine cold before
starting.
2. Check the gear oil level in the reservoir located on the engine. Keep
the gear oil level at the recommended ranges as marked on the reservoir.
If any water is visible at the bottom of the reservoir or there are any
metal chips in the drive oil do not run the engine since component
damage can result. Contact your Regal dealer for more information.
Filling the Stern Drive
1. If more than 2 ounces of High Performance
Gear Lubricant is required to fi ll the monitor
reservoir a seal may be leaking. Contact your
Regal dealer.
2. If drive lubricant is free from water and
metal chips proceed to fill the reservoir.
Remove the gear lube monitor cap. Fill
the reservoir with High Performance Gear
Lubricant (Merc part # 92-802854A1).
A=Drive Reservoir
A
To Next Page
Loading...
