STEREO DIAGNOSTIC CHART
Problem Possible Cause
No Power At Stereo Battery switch turned off
Fuse is blown - investigate why the
equipment was drawing too much current
or why it had a circuit short. Check
ignition panel breaker, memory fuse
in engine compartment, memory fuse
underneath dash, and ignition protection
fuse underneath dash
Water in unit
Stereo Will Not Play Water in unit
Radio Signal Unavailable
Bad antenna
Mode selection isn’t correct
Stereo Memory Lost Stereo memory fuse in engine
compartment or underneath dash is
blown - investigate why the equipment
was drawing too much current or why it
had a circuit short
No Output Sound / Volume Is
Low / Sound Is Distorted
Balance and max volume settings are
limiting the speaker volume - adjust zone
settings and setup settings
Rotary encoder malfunction
Loose speaker wire
Water in speakers
Added Performance Package
Speakers Working Only
Amplifi er fuse blown - investigate why
the equipment was drawing too much
current or why it had a circuit short
8-8
Chapter 8
To Next Page
Loading...
