9
Engine & Controls
TYPICAL REMOTE CONTROL
Trim Switches
Typical Throttle Only
Button
Trailer Buttons
When operating your vessel you may notice that even
though the control handles are in the relatively same
position the engine tachometers may not be exactly the
same. This is a normal condition. Simply adjust the throttle
handles to equalize the engine rpm’s.
Avoid shifting into reverse while the boat is making
forward headway. While docking make the best use of
the twin engine feature by maneuvering using the gear
shifts only in the idle throttle position. This will allow
you to enter and exit a mooring or dock easier and helps
keep the operator from overeacting in close quarters. For
more specific information refer to the remote control
manufacturer’s owners manual.
TO PREVENT POSSIBLE CONTROL/STERN
DRIVE DAMAGE THE REMOTE CONTROL
SYSTEM MUST BE LUBRICATED
PERIODICALLY. REFER TO THE REMOTE
CONTROL AND ENGINE MANUFACTURER’S
OWNERS MANUAL.
NOTICE
Remote Control Shown In Neutral Detented Position
To Next Page
Loading...
