22
Manual CORRIGO C-SERIES 2000.09
To log in to another user level.
Press Ç or È until the cursor arrow points at Login. Press OK.
The login menu will be displayed.
To log in press ! and a marker will be shown on the first digit. Press ÇÈ to
change the value.
Press OK to move to the next digit. To return to the previous digit press Esc. After
the last digit the code is evaluated.
The operation can be aborted by means of Esc.
If an incorrect code is given an error message is displayed:
The correct code will result in an acknowledging message showing the login level.
After 2 seconds the system automatically returns to the main menu.
Factory set codes
The codes for the three user levels are factory set as follows
User level 1 1111
User level 2 2222
User level 3 3333
Changing codes
The codes for the three user levels can easily be changed in user level 3.
Enter the login menu:
The arrow means that there are menus below, press the arrow until the code for
level 1, 2 or 3 is displayed.
Change the code using !.The cursor will start on the first digit. Change using the
arrow buttons. To move to the next digit press OK. To return to the previous digit
press Esc.
By pressing OK after the last digit the code will be registered. To abort use Esc.
DO NOT FORGET TO MEMORIZE THE NEW CODES or to write them down. This
is especially important for user level 3. Should the code for level three be lost the
system can be opened by means of a code number which can be obtained from
REGIN. This code number is time dependent.
Set your code
0000 Level:0
Incorrect code
try again
Login ok
Code:0
Set your code
0000 Level:3 â
Code for level1á
1111 â
Code for level2á
2222 â
Code for level3á
3333 â
Important !
To Next Page
Loading...
Need help?
General
