44
Manual CORRIGO C-SERIES 2000.09
Relay modules for digital outputs
CORRIGO has digital outputs DO1 to DO6 carrying 24 V AC with up to 0.5 A.
If higher voltage and/or capacity is required, relay module RM6-24/D or
RM6H-24/D can be used.
Model RM6-24/D contains 6 relays with change-over relays 10A / 230V AC.
Model RM6H-24/D is as RM6-24/D but also has manual switches on the front,
MANUAL-0-AUTO.
When the relay module RM6H-24/D with manual switch is used in conjunction with
CORRIGO, output DU6 must be configured for frost protection output and DI6 to
receive the alarm ”switch not in AUTO-mode”. The switch for DU6 on the relay
module must always be in the AUTO mode.
Model RM6H-24/DModel RM6-24/D
Relay modules
RM6-24/D
Relay unit intended for direct connection to CORRIGO
Supply voltage 24V AC +/- 15%
Consumption 3VA
Ambient temperature 0-50 deg.C.
Storage temperature -40 - +50 deg.C.
Ambient humidity Maximum 90% RH
Dimensions (w x h x d) 105 x 110 (incl.terminal) x 59 mm
Protection class IP20, for front mounting IP40
Mounting On a DIN-rail in a cabinet or normal housing.
On cabinet front using mounting kit FMC.
Connections Disconnectable terminal strips
Inputs 6 in number, 24V AC from digital outputs on CORRIGO
Outputs 6 in number, potential free change-over contacts
10 A / 230 V AC.
RM6H-24/D
Relay unit as above but with 6 Manual-0-Auto switches.
The unit is 70 mm deep including the switches.
This product conforms with the requirements of Euro-
pean EMC standards CENELEC EN 50081-1 and EN
50082-1 and carries the CE mark.
This product conforms with the requirements of
European LVD standards IEC 669-1 and IEC 669-2-1.
To Next Page
Loading...
Need help?
General
