General information
2 General information
2.1 DIN rail mounting inside a cabinet
To mount the controller:
1. Pull out the fastener.
2. Attach the controller to the rail.
3. Push in the fastener to secure the controller.
Figure 2-1 Attaching the controller to the DIN rail.
2.2 Maintenance and service
WWaarrnniinngg!! Before installation or maintenance, the power supply must first be disconnected in order to
prevent potentially lethal electric shocks! Installation or maintenance of this unit should only be carried
out by qualified personnel. The manufacturer is not responsible for any eventual damage or injury
caused by inadequate skills during installation, or through removal of or deactivation of any security
devices.
2.2.1 Changing the battery
WWaarrnniinngg!! To prevent electric shock, the controller must be disconnected from power before the
battery is changed.
To change the battery:
1. Disconnect the controller from power, and then remove the terminal protection covers (if wall
mounted).
6
EXOcompact Ardo, Eedo and Vido manual, Rev.
B
To Next Page
Loading...
Need help?
General
