Need help?Do you have a question about the REHM TIGER 210 AC/DC and is the answer not in the manual?
Explains the meaning of safety symbols used within the operating manual for hazard identification.
Identifies and explains the meaning of warning symbols located directly on the welding unit.
Covers general safety guidelines, compliance with regulations, and power supply requirements.
Details the layout, symbols, and general description of the control panel elements.
Covers essential welding functions like current settings, pulsing, downslope, and trigger modes.
Covers the Special Mode for setting numerous parameters and functions, including program save/load.
Provides essential safety precautions and warnings before operating the welding unit.
Ensures compliance with electrical safety regulations and specifies unit behavior during AC welding.
Details the correct procedures and regulations for connecting the welding unit to the mains power supply.
Emphasizes safety precautions for trained personnel operating the welding equipment.
Details critical electrical safety measures to prevent shock during operation and maintenance.
Covers personal protective equipment and warnings regarding arc radiation and compressed gases.
Outlines essential checks and assumptions to be made before powering on the welding unit.
Explains the correct procedure for connecting the earth cable for effective and safe welding.
Emphasizes immediate work stoppage and safety measures when faults occur.
Provides a comprehensive table listing common faults, possible causes, and recommended remedies.
Stresses that only REHM-trained personnel should perform maintenance and use original spares.
Outlines a table of recommended maintenance actions, intervals, and related chapters.
General| Welding Process | TIG, MMA |
|---|---|
| Input Voltage | 230 V |
| Input Frequency | 50/60 Hz |
| Welding Current Range TIG | 5 - 210 A |
| Welding Current Range MMA | 10 - 170 A |
| Protection Class | IP23 |
| Rated Input Voltage | 230 V |
| Duty Cycle MMA | 170 A / 25% at 40°C |
| Cooling | Air |
| Rated Input Power | 5.5 kVA |
To Next Page