12
Further notes see chapter 7 „Maintenance“.
4.3 Investment (manufacturer’s recommendation)
• The diameters of the channels to the supplier should be 4,5 – 5 mm, the short sprueings to
the object should be 2,5 –3 mm.
• Muffle surface and floor space must be rough and at the same time be grinded according
to corresponding muffle size (we recommend to use a Velcro disc at the trimmer. Diamond
discs tend to be easily damaged by the muffle ring and some investment compounds).
• Caution: Don’t use any wax softening agents
• Wall thickness:
non-precious metal/precious metal crowns and dental bridges
Minimum 0,3 – 0,5 mm
model casting Minimum 0,5 mm
generally for precious metals Minimum 0,3 mm possible
4.4 The display panel of your INDURET- COMPACT
A) Key Function:
01 – Key P Entry confirmation and changing the temperature when programming
02 - Key down Reduce values or select
03 – Key up Increase values or select
04 – key U (This key is without any function if your controller only has one
memory cell)
In order to obtain further dental sprueing information pls. read the delivered instructions.
„The right way“.
To Next Page
Loading...