REITER AGR-08-E - Page 26

S-AGR08-Egb08 05/15 - 3 Page 7 of 15
8 Maintenance
 4. Turngunto180°(needleup),placeuidnoz-
zleandtightenitto30Nm.Placeaircapand
tighten it manually with retaining ring. Little
gun grease on the threads facilitates subse-
quent removal.
 5. Wetslightlytwoo-rings(10)fromnotsolvent
resistantViton,forfanairandatomizingair
with gun grease and insert into the head hold-
er(11).
Attention: Too much grease can be carried
away by the fan air and atomizing air and
reected in painting/coating on the work-
piece.
 6. Lubricatepiston(12)andpushintothehead
holder(11)manually.
 7. Fitsprayhead(8)andheadholder(11)to-
gether.