Reloop MIXAGE Interface Edition User Manual

ENGLISH
43
7.3 TROUBLESHOOTING
If any problem should arise while using Reloop Mixage the following chart is the rst drop-in center:
Symptoms Possible Causes Corrective Measures
The device does not recei-
ve any power when turning
it on via the ON/OFF But-
ton -B41-.
USB cord or mains ad-
apter are not correctly
connected.
Check whether the USB cord is connec-
ted correctly to a free USB port of your
computer and Mixage‘s USB port -B42-.
Please also check whether the mains ad-
apter is connected correctly to the mains
connection -B40-.
The controller‘s LEDs are
only weakly lit and the
device does not react.
The power supply is not
sufcient.
Connect your computer to a secured pow-
er line. Also it is necessary to connect the
included mains adapter to the correspon-
ding jack -B40-.
Not all outputs of the
integrated audio interface
can be selected in the DJ
software.
The ASIO driver is not
installed correctly.
Please install the ASIO driver again. Also
please read the paragraph „ASIO Driver
Installation“ in the chapter „Computer
Conguration“.
The audio interface's
sound is distorted.
The ASIO driver is not
used.
The performance set-
tings of your computer
do not correspond to
the computer‘s capa-
city.
Please make sure that the ASIO driver is
installed and is also being used. Please
refer to the paragraph „ASIO Driver
Installation“ in the chapter „Computer
Conguration“.
It is also possible that in the ASIO
driver‘s settings the available computer
capacity has to be re-congured. Open
the settings in Traktor, select the ca-
tegory „Audio Setup“ and click on the
„Settings“ button next to the sound card
selection window. Then select „System
Performance“ ? „Normal“. If the prob-
lems persists you can also select „Re-
laxed“ in the same menu.
The DJ software does
not show any reaction to
the usage of any of the
contoller‘s control ele-
ments.
Traktor LE is not con-
gured correctly.
Traktor Pro is not ins-
talled correctly.
MIDI channel is not
selected correctly.
If you use the included Traktor LE versi-
on, start the Setup Wizard again. Refer to
the paragraph „Traktor LE Setup“ in the
chapter „Computer Conguration“.
When using Traktor Pro the mapping has
to be loaded again. To do so follow the
instructions in the paragraph „Trakto Pro
Conguration“ in the chapter „Computer
Conguration“.
Check the MIDI Channel Switch -B43- and
put it in the right position (ch. 1 or ch.
2). Please refer to the paragraph „MIDI
Channel Assignment“, chapter „Device
Settings & Tests“.
A problem occurs that is
not listed in this chart.
Various causes. Visit www.reloopdj.com/forum, in order
to get support regarding your Reloop
products.

Reloop MIXAGE Interface Edition Specifications

General

Brand	Reloop
Model	MIXAGE Interface Edition
Category	Recording Equipment
Language	English