Installation, start up and operating manual – version 5.3 Gen.10
Radio control BRICK and PAIL
PAIL
• turn and disengage the EMERGENCY STOP button
• Move Joystics 1 and 2 in the arrows direction and at the same time
press the START button, and then release
• the channel set and the frequency are indicated by the number of
flashes of the green led for unit and red led for tens: see table
in Figure 15
The completion of this sequence accesses “PROGRAMMING MODE”:
• with pushbutton 3 each press means one CHANNEL down
• with pushbutton 4 each press means one CHANNEL up
• with pushbutton 5 each press means ten CHANNEL down (434MHz
only)
• When you have chose the needed frequency press and keep pressed
the EMERGENCY STOP button for a few seconds en then disengage
it.
• Press and keep pressed the START button for a few seconds (until
the machine starts up)
REMdevice
®
- ITALY
25
To Next Page
Loading...
